v0.04 * Added 'cm' command to copy memory inside the monitor. * Added support for faster tracing of some opcodes. See the manual for more information. * 'm', 'ma' and 'd' commands can now use register parameters, eg. "hl "ix to show the memory or opcodes at the value from the register. * You can now specify * as the size for the 'lm' load memory command to load all of the file. v0.03 * Added 'rm' command to delete a file. * Added 'lg' command to write a message to the log file (/tmp/mon_log.txt). 'lg' displays the contents of the log. 'lg !' deletes the log, 'lg +' copies subsequent output to the log file and 'lg -' stops this re-direction. This lets you dump memory and disassembly along with your own comments to a readable text file. * Added 'fc' command to compare a section of memory with the contents of a saved file. * Added fast command key - executed by pressing EXTEND MODE. Currently only used when tracing, e.g. after returning to the monitor from the trace, pressing EXTEND MODE will immediately execute another trace command. * 'ls' command now shows 16 bit file size (< 65536) for files. * Monitor now remembers the last used address between sessions. * Fixed issue where pressing cursor to recall the last entered command could copy from uninitialised memory leading to a corrupted line with an odd cursor position being shown. * Loading a snapshot in with 'la' will now display the disassembled opcode at the program counter after displaying the Z80 registers. * Monitor now shows the disassembled opcode at the program counter on startup. * Fixed situation where trace got into an infinite loop of breaking into the monitor when encountering unsupported opcodes. * Trace now supports jp (hl/ix/iy) opcodes. v0.02 * 'p' command now lets you POKE a string into memory. * Improvements to text entry - you can now cursor through the line and delete characters. * Added fossimon .dot command to do the soft installation of NMI.SYS. * 'm' and 'd' commands now work like the 'ma' command - they will continually dump and disassemble on a keypress until you press BREAK. * Stop buffer overflow if you typed in a line of text the width of the screen. * Added 'pg' page command to swap the current 128k paged bank at 49152. * 'd' command without a parameter will now continue disassembly after the last address used by the 'm' or 'ma' commands. * Added optional + parameter to 'sm' command to save a file with a PLUS3DOS header. * Setting a single byte register (I, IFF2, IM) didn't work correctly. * Pressing cursor up will recall the last entered command. * Added NMI_KEY.SYS which starts the monitor if SYMBOL SHIFT is held down when pressing the NMI or the long filename browser if it isn't. * You can now break / exit out of search results at the 'More...' prompt if the 'fi' command lists too many results. v0.01 - INITIAL RELEASE