[EN] [CZ] STEP (STEP INTO) Executes the current instruction. If the instruction is a call of a subroutine, it enters the subroutine and stops at the first instruction in the subroutine. STEP OVER Executes the current instruction, and if that instruction is a call to a subroutine (CALL, RST), executes the entire subroutine. It stops after returning from the subroutine, on the instruction following after the subroutine call. LDIR, LDDR, and HALT are similarly accelerated. This will execute a whole routine we don't want to trace step by step. Be careful: in a routine called this way, via CALL or RST, the return address may not be changed or a return may not be performed by another command than RET. When returning from an esxDOS service called with RST8, the debugger does not go to the instruction immediately after RST, but one byte further on, because such a RST is followed by a DEFB with a number for an esxDOS function. STEP OUT Executes the instruction till a return (by RET) to an address according to the current SP. When STEP OUT is started, the current return address from the stack is taken into account and instructions are executed until this address is reached. When doing STEP OUT, additional CALL instructions will be executed, incl. all returns from subroutines. The execution of instructions will not stop until the PC reaches the address originally stored on the stack. So if we are in a subroutine, this will execute all remaining instructions of the subroutine and returns from it. This is how we leave of a routine we don't want to step through. [CZ] STEP (STEP INTO) --------------------------------------------------------------- Vykoná aktuální instrukci. Pokud je tou instrukcí volání podprogramu, vstoupí do něj a zastaví se na první instrukci v podprogramu. STEP OVER --------------------------------------------------------------- Vykoná aktuální instrukci a pokud je touto instrukcí volání podprogramu (CALL, RST), provede jej celý. Zastaví se až po návratu z podprogramu, na instrukci následující po volání podprogramu. Podobně urychluje LDIR, LDDR, ale i HALT. Tímto najednou provedeme rutinu, kterou nechceme krokovat. Pozor, aby se v rutině takto volané přes CALL nebo RST neměnila návratová adresa nebo nebyl návrat prováděn jiným způsobem než pomocí RET. Pokud se jedná o návrat ze služby esxDOSu volané pomocí RST8, nevrací na instrukci hned za RST, ale až o bajt dál, protože za RST je DEFB s číslem funkce pro esxDOS. STEP OUT --------------------------------------------------------------- Provede instrukce do návratu (pomocí RET) na adresu dle aktuálního SP. Při spuštění STEP OUT se poznamená návratová adresa ze zásobníku a instrukce se provádějí, dokud se této adresy nedosáhne. Budou přitom prováděny další příkazy CALL a návraty z nich. Provádění instrukcí se však nezastaví, dokud PC nedosáhne adresy, co byla původně na zásobníku. Nacházíme-li se v podprogramu, tímto se vykonají všechny zbývající instrukce podprogramu a dojde k návrat z něj. Tak se "vymaníme" z rutiny, kterou nechceme krokovat.